Filter
Top Products
SDSFE31xx-100 Industrial Device Server Transition Networks
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
17
Connecting fiber cables
Fiber cable
installation
When connecting fiber cables to the 100BASE-FX port on the Device Server, make
sure the correct type is used: ST or SC.
To install the fiber cables, do the following:
Step Action
1. Remove and keep the rubber fiber-port-protector cover shown below.
Note: When not connected to a fiber cable, insert the rubber protective cover into
optic port to protect the optics.
2. Check that the fiber terminators are clean. If necessary, clean the fiber
connectors using locally accepted cleaning procedures.
Note: Dirty fiber connectors on fiber optic cables will impair light transmission
quality through the cable and lead to degraded performance on the port.
3. Connect the fiber cable as shown in Figure 11.
Figure 11: Fiber Cable Connections
4. Check the corresponding fiber port LED on the Device Server to verify
the connection—Link/Act LED should be lit.
Warning
• Visible and invisible laser radiation when open: DO NOT stare into the
beam, or directly view the beam with optical instruments. Failure to observe
this warning could result in an eye injury or blindness.
• Use of controls, adjustments or the performance of procedures other than
those specified herein may result in hazardous radiation exposure.