Filter
Top Products
-22-
V. REMOVAL/INSTALLATION
4. At the top of the junction box,
remove three (3) Phillips head
screws. Set screws aside.
5. Locate one (1) Phillips head
screw at bottom of junction box,
and remove. Set screw aside.
6. Carefully slide junction box
away from front of unit until all
wiring and connections to the
controller are exposed.
7. Locate all nine (9) Controller
connections (five for G-Series),
then carefully disconnect each
one.
8. Firmly grasp and compress the
rounded portion of the middle
prong on each holder clip.
Slowly slide each holder clip off
the controller. Set clips aside.
9. Slowly pull Controller through
mounting hole and set aside.
WARNING: DISCONNECT ALL POWER BEFORE PROCEEDING
TO RE-INSTALL CONTROLLER,
REVERSE THE PRECEEDING
PROCEDURE.
NOTE:
Be sure ALL components
have been disconnected
from the Controller before
performing the next step.
CONTROLLER
PULL CONTROLLER
IN THIS DIRECTION
(3) PHILLIPS
HEAD SCREWS
(1) PHILLIPS
HEAD SCREW
JUNCTION
BOX
REAR VIEW
OF UNIT
CONNECTIONS
CONTROLLER
JUNCTION
BOX
(relay junction
box shown
turned 90
degrees)
MIDDLE
PRONG
HOLDER
CLIP
HOLDER
CLIP