Filter
Top Products
Step 1: Press . Display will read “CUS.”
Step 2: Press until “EnG” is displayed.
Step 3: Press . Display will read “000” with the left digit flashing.
Step 4: Press until the left digit changes to an “9”.
Step 5: Press . Display will read “900” with the center digit flashing.
Step 6: Press until the center digit changes to an “9”.
Step 7: Press . Display will read “990” with the right digit flashing.
Step 8: Press until the right digit changes to an “E”.
Step 9: The display will read (99E), press .
Step 10: Press . The display will now read “FOC”
- See Note.
NOTE: R & A Series Only, for G-Series models press for the
control to display “FOC.”
SET
The Display
Will Read
SET
SET
SET
SET
-31-
VII. ACCESSING THE ENGINEERING LEVEL
VII. a - ACCESSING THE ENGINEERING LEVEL:
Not all control parameters can be adjusted at the customers level of access.
To adjust these other parameters it is first necessary to gain access to the
ENGINEERING LEVEL. Please follow the below procedure in order to enter
this level.