Filter
Top Products
1. Follow steps one through three of ‘How To Operate Your Blending Station
Using The Six Pre-Set Programmed Buttons’ section on page 14.
2. The speed of the motor can be changed with:
3. The PULSE buttons can also be used to quickly increase the motor speed
or decrease the motor speed. (See HIGH/LOW PULSE button description
on page 5.)
4. When done blending press the START/STOP button to stop the motor.
Wait until blade comes to a complete stop before removing the lid
and/or container from the motor base.
5. Remove the container from the motor base and serve the drink.
NOTE: On all units the built-in thermal sensor keeps track of how hot the
motor gets and will warn the user and eventually shut down the motor if the
motor is overheating. When overheated the display will instruct the user to
remove the container and run the machine until cool. This takes about a
minute. See page 25, “Cooling the motor,” for complete instructions.
When overheating occurs, review your techniques and instructions. The
motor may be getting hot when your recipes are too thick. Consider adding
more liquid and consult Vita-Mix for further assistance.
I
nstructions
16
CONTINUED FROM PAGE 15
• the motor off.
– Press the ▲ or ▼ buttons
until the desired speed
percentage is displayed.
100% is the highest setting
and 7% is the lowest setting.
– When the START/STOP button
is pressed the motor will ramp
quickly to that speed
– Blending can be stopped by
pressing the START/STOP
button at any time.
• the motor on.
– With the container in place press
the START/STOP button. The
machine will begin blending.
– While the machine is running
Press the ▲ or ▼ buttons
until the desired speed
percentage is displayed.
100% is the highest setting
and 7% is the lowest setting.
– Release the SPEED CONTROL
button and the motor will now run
at the desired speed.
– The blending can be stopped by
pressing the START/STOP button.