Filter
Top Products
The Touch and Go
TM
Blending Station
®
advanced electronic control can be
custom programmed, requiring an optional programming chip, available
from Vita-Mix for a nominal fee and with a minimum unit purchase. Contact
your Vita-Mix representative for more information .
Programming your Touch and Go
Blending Station PRE-SET buttons
1. Insert the custom programmed chip with the
words, “THIS SIDE FACING TO THE FRONT
OF THE MACHINE” toward you, into the port
located below the label area on the front of the
Blending Station. The DISPLAY WINDOW will
read ‘New Module’.
2. Within 10 seconds the SIX PRE-SET buttons will be re-programmed and
the DISPLAY WINDOW will read ‘Saved’ then ‘Ready’. If nothing happens
when the programming chip is fully inserted, turn the chip in the opposite
direction and try again.
3. Remove the programming chip and return it to the original package.
4. Press one of the six PRE-SET buttons to reveal, in the DISPLAY WINDOW,
the name of the program/drink.
NOTE: If for any reason the programmed times are incorrect, they can be
reset to the original factory settings following the instructions on page 7.
Programming your In Counter Touch and Go
Blending Station PRE-SET buttons
1. Remove the container from the machine.
2. Lift the machine from the bottom edges to reveal the motor and housing
area. With the machine facing towards you, locate the slot underneath on
the right hand side of the machine between the motor and the outer wall.
3. Insert the custom programmed chip into the slot with the words, “THIS
SIDE FACING TO THE FRONT OF THE MACHINE” turned facing out to
the right of the machine. Once inserted the DISPLAY WINDOW will read
‘New Module’.
C
ustom Programming
Custom
Programmed
Chip
6