Filter
Top Products
Two-part Lid
48 oz. polycarbonate container
The two part lid is easy to clean and easy to put on,
take off & seal.
• To remove fully latched lid, squeeze tabs
together on both sides of the container, pull
upward and off.
• Twist the center lid plug to fasten or remove.
NOTE: To make new lids easier to insert and remove, rub a light coating of
cooking oil around bottom where it seals. Place it in container for several
minutes, remove and lightly wipe oil off lid.
Two-part Lid
64 oz. polycarbonate container
The two part lid is easy to clean and easy
to put on and take off. (Note: Brand new
lids are a little stiff. This is temporary.)
• The lid has a continuous rim which
latches inside the container tabs.
Push one side of the rim under one
tab, and with the heel of your hands
push down, over the opposite tab,
to snap lid into position.
• To remove lid, place hands around
the lid, pressing thumbs above
one of the container tabs. Push
in and lift off.
• Twist the center lid plug to fasten
or remove.
CUPS
Figure A
Figure B
8
To secure lid plug, rotate it
so one tab locks between the
stops on top of rubber lid.
Always latch lid when
processing hot liquids.
Press in
above
container
tab to
remove
lid
Rim
Container
Tab
L
id Assembly