Filter
Top Products
16
1. Follow steps 1 through 3 of “How to operate your Blending Station
®
MP using the
Six Pre-Set Programmed Buttons” section on page 14.
2. The speed of the motor can be changed with:
3. The PULSE button can also be used to quickly increase the motor speed or
decrease the motor speed. (See HIGH/LOW PULSE button description on page 5.)
4. When done blending, press the START/STOP button to stop the motor.
Wait until blade comes to a complete stop before removing the lid
and/or container from the motor base.
5. Remove the container from the motor base and serve the drink.
NOTE: On all units, the built-in thermal sensor keeps track of how hot the motor gets
and will warn the user and eventually shut down the motor if the motor is overheating.
When overheated, the display will instruct the user to remove the container and run
the machine until cool. This takes about two minutes. See page 25, “Cooling the
motor,” for complete instructions. When overheating occurs, review your techniques
and instructions. The motor may be getting hot when your recipes are too thick.
Consider adding more liquid and consult Vita-Mix
®
or your local Vita-Mix Distributor
for further assistance.
I
nstructions
CONTINUED FROM PAGE 15
• the motor off.
– Press the ▲ or ▼ buttons
until the desired speed
percentage is displayed.
100% is the highest setting
and 7% is the lowest setting.
– When the START/STOP button is
pressed, the motor will ramp
quickly to that speed.
– Blending can be stopped by
pressing the START/STOP
button at any time.
• the motor on.
– With the container in place, press the
START/STOP button. The machine
will begin blending.
– While the machine is running, press
the ▲ or ▼ buttons
until the desired speed
percentage is displayed.
100% is the highest setting
and 7% is the lowest setting.
– Release the SPEED CONTROL
button and the motor will now run at
the desired speed.
– The blending can be stopped by
pressing the START/STOP button.