The Blending Station
®
MP is packaged with an MP smoothie programming chip.
Please keep the chip in a safe, easily accessible spot and always keep it in the
original package. This chip is used to program your machine with the six smoothie
programs optimized for the MP48 container.Although your machine comes from
the factory pre-set with the MP programs, follow these instructions, when using
the supplied programming chip, in the event your machines PRE-SET buttons
were altered.
Programming your On-Counter Blending Station
MP PRE-SET buttons
1. Turn the machine on.
2. Facing the front of the machine, insert the custom
programmed chip with the words, “THIS SIDE FACING
TO THE FRONT OF THE MACHINE” toward you and
the silver contact bars up, into the port located below
the label area on the front of the Blending Station MP.
The DISPLAY WINDOW will read “NEW MODULE.”
3. Within 10 seconds the six PRE-SET buttons will be
re-programmed and the DISPLAY WINDOW will read
“SAVED” then “READY.” If nothing happens when the programming chip is fully
inserted, turn the chip in the opposite direction and try again.
4. Remove the programming chip and return it to the original package.
5. Press one of the six PRE-SET buttons to reveal, in the DISPLAY WINDOW, the
name of the program/drink.
Programming your In-Counter Blending Station MP
PRE-SET buttons
1. Turn the machine on.
2.
Remove the container from the machine.
3.
Lift the machine from the bottom edges to reveal the motor and housing area.
W
ith the machine facing towards you, locate the slot underneath on the right
hand side of the machine between the motor and the outer wall.
C
ustom Programming
P
E
RFORMANCE
M
AXIMUM
Custom
Programmed
Chip
6