Filter
Top Products
FULL SIZE GAS CONVECTION OVENS - REMOVAL AND REPLACEMENT OF PARTS
F24682 (Rev. B, October 2007) Page 14 of 68
NOTE: The door assembly is heavy and will drop
down once the last screw is removed. If removing
door assembly with-out assistance, the ignition
cable, flame sense lead and gas manifold should
also be removed to avoid damage to these
components.
5. Lift up on the door assembly and swing the right
side out then move the assembly to the left to
clear the slots in the upper door sill.
6. Lay the door assembly on a flat cushioned
surface for disassembly.
7. Reverse procedure to install door assembly and
check for proper adjustment as outlined under
DOOR ADJUSTMENT, DOOR CHAIN
ADJUSTMENT (SIMULTANEOUS DOORS)
and DOOR SWITCH ADJUSTMENT in
SERVICE PROCEDURES AND
ADJUSTMENTS.
Disassembly
1. Remove the door assembly as outlined in
OVEN DOORS (SIMULTANEOUS) under
ASSEMBLY REMOVAL.
2. Remove the door chain by loosening one of the
turnbuckles.
3. Loosen the set screw on the sprocket of door
being replaced.
4. Drive out the spiral pin from the sprocket of door
being replaced.
5. Remove the door from lower sill bearings and
sprocket.
A. Door assembly parts are now accessible
for inspection and/or replacement if
necessary.
6. Reverse procedure to re-assemble the door
assembly parts and check for proper adjustment
as outlined under DOOR CHAIN ADJUSTMENT
(SIMULTANEOUS DOORS) in SERVICE
PROCEDURES AND ADJUSTMENTS.
ROLLER LATCH ASSEMBLY
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made after 8/12/07 and serial number starting with
54 made after 8/26/07.
1. Remove the screws that attach roller latch
assembly to door.
2. Reverse procedure to install.