Filter
Top Products
FULL SIZE GAS CONVECTION OVENS - REMOVAL AND REPLACEMENT OF PARTS
F24682 (Rev. B, October 2007)Page 17 of 68
3. Disconnect lead wires from high limit thermostat
then remove high limit thermostat from
cover/mounting plate.
NOTE: Remove the old RTV from the cover and
mating surfaces inside the oven cavity and apply
new RTV before installing.
4. Reverse procedure to install.
INTERIOR LIGHTS
Lamp
1. Remove the racks.
2. Unscrew the glass lens for the light being
replaced then unscrew the bulb.
3. Replace bulb then reverse the procedure to
install.
Lamp Assembly
1. Remove the lens and bulb.
2. Remove the springs from the retaining tabs (2
places) on the socket.
3. Depress the retaining tabs and pull the socket
out from the oven, far enough to disconnect the
lead wires.
4. Remove the socket from the oven.
5. Attach the lead wires to the replacement socket.
6. Insert the socket into the hole in the oven and
push until the socket is held in place by the
retaining tabs.
7. Install the light bulb and lens.
8. Check for proper operation.