Filter
Top Products
FULL SIZE GAS CONVECTION OVENS - REMOVAL AND REPLACEMENT OF PARTS
F24682 (Rev. B, October 2007)Page 15 of 68
DOOR CATCH BALL ASSEMBLY
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made before 8/13/07 and serial number starting with
54 made before 8/27/07.
1. Remove the top front cover as outlined under
COVERS AND PANELS.
2. Remove the screws that secure the door catch
assembly.
3. Reverse procedure to install.
4. Adjust the ball catch as outlined under DOOR
CATCH BALL ADJUSTMENT (INDEPENDENT
DOORS) in SERVICE PROCEDURES AND
ADJUSTMENTS.
DOOR WINDOW
1. Remove the screws at the top and bottom of
door.
2. Independent doors:
A. Remove the door handle then remove the
outer door panel.
B. Lift out the inner door panel and window
assembly.
NOTE: Left door only - remove door seal from
the inside edge of the door.
3. Simultaneous doors:
A. If replacing window on the left door,
remove the handle from the front of the
door then remove door seal from the inside
edge of the door.
1) Lift out the inner door panel and
window assembly.
2) If replacing window on the right door,
remove the screws along the inside
edge (if applicable) of the door then
remove the inner door panel and
window assembly.
4. Remove the screws securing the window TABS
to the door bracket and lift the window assembly
out from the door frame.