Filter
Top Products
INTERIOR LIGHTS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Do not touch the Halogen lamp with bare
hands. If lamp is exposed to oil from the skin, the life
will be reduced. Ensure lamp is free from oil and dirt
before replacing.
Bulb Replacement
1. Pull lamp cover off.
2. Grasp lamp using a clean cloth and remove from
lamp assembly.
Fig. 21
3. Reverse procedure to install new bulb.
Lamp Assembly Replacement
1. Remove racks in cavity.
2. Pull lamp cover off.
3. Remove RIGHT SIDE - REAR PANEL.
Insert screw driver and push lamp assembly out
into cavity.
Fig. 22
4. Disconnect wires.
5. Reverse procedure to install new lamp assembly.
COOLING FAN
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the
RIGHT SIDE - FRONT PANEL.
NOTE: If right side - front panel is not accessible, this
component can be serviced by removing the
CONTROL PANEL.
2. Remove wire nuts from fan wire connections.
VC3ED FULL SIZE ELECTRIC CONVECTION OVEN - REMOVAL AND REPLACEMENT PARTS
F45534 (0415) Page 12 of 31