Filter
Top Products
Fig. 12
3. Remove racks from cavity.
4. Remove FAN COVER.
Loosen element screws on side wall.
5. Remove screws on back wall holding brackets.
6. Pull elements forward, then away from right wall.
Heating Element
7. Reverse the procedure to install the replacement
heating element.
BLOWER AND MOTOR
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Take out the racks and rack supports.
2. Lift off FAN COVER.
3. If replacing:
A. Blower Only - Loosen bolts on blower hub
and using a bearing puller, remove blower
from motor shaft.
1) Reverse procedure to install and adjust
blower position as outlined under
BLOWER ADJUSTMENT under
Service Procedures and Adjustments.
B. Motor - perform step 3A and continue
procedure.
4. Remove bolts that secure the motor mounting
plate to the rear wall.
Fig. 14
5. Place a piece of cardboard on the bottom of the
oven cavity to protect its surface from any
damage during motor assembly removal.
6. Pull the motor assembly into the oven cavity and
place it on the cardboard.
7. Remove the junction box cover from the motor,
disconnect lead wires and remove the conduit.
VC3ED FULL SIZE ELECTRIC CONVECTION OVEN - REMOVAL AND REPLACEMENT PARTS
Page 9 of 31 F45534 (0415)