Filter
Top Products
REMOVAL AND REPLACEMENT PARTS
COVERS AND PANELS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Bottom Front Cover
1. The bottom front cover is secured with four (4)
screws, two on each side of cover. Remove these
screws then remove cover from oven.
Fig. 1
2. Reverse procedure to install. Verify bottom cover
is seated under front plate.
Fig. 2
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Control Panel
1. Remove three (3) screws on the right side which
secure the control panel then left up and pull
away.
Control Panel Cover
2. Disconnect temperature probe leads from solid
state temperature control.
3. Disconnect fuse wires.
4. Unplug wire harness connector to control panel
components.
5. Reverse procedure to install.
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Right Side - Front Panel
1. Loosen two screws near front of oven, which
secure bottom front cover.
VC3ED FULL SIZE ELECTRIC CONVECTION OVEN - REMOVAL AND REPLACEMENT PARTS
Page 5 of 31 F45534 (0415)