Filter
Top Products
Attaching the ice maker to a water supply
Read all directions carefully before you begin.
Cold water supply
Ice maker water valve contains a flow
washer which is used as a water pressure
regulator. The ice maker needs to be
connected to a cold water line with water
pressure limitations of 20-120 PSI. If a
problem occurs, call your utility company.
IMPORTANT:
Electrical Shock Hazard
Unplug the refrigerator before
installing ice maker.
Fallure to do so can result in death
or electrical shock.
IMPORTANT:
l It may take up to 24 hours for your ice
maker to begin producing ice.
l If operating the refrigerator before install-
ing the water connection, turn ice maker to
the OFF position to prevent operation
without water.
l All installations must be in accordance with
local plumbing code requirements.
. Use copper tubing only and check for leaks.
l Install ice maker tubing in areas where
temperatures are above freezing.
Tools required:
l Standard screwdriver
l ‘he-inch and M-inch open-end wrenches or
2 adjustable wrenches
l %-inch nut driver
l %-inch drill bit
l Hand drill or electric drill (properly grounded)
NOTE: Your appliance dealer has a kit
available with a X-inch saddle type shut-off
valve, a union, and copper tubing. Before
purchasing, make sure a saddle type valve
complies with your local plumbing codes.
Do not use piercing type or %-inch saddle
valve which reduces water flow and clogs
more easily.
INSTALLATION IS NOT WARRANTED
BY REFRIGERATOR OR ICE MAKER
MANUFACTURER.
17