Filter
Top Products
Page 1-1
1-1
Cooking Products Service Manual
Original July, 1996 4321891
© 1996 Whirlpool Corporation
RANGE DIMENSIONS
GENERAL
Proper installation is your responsibility. A quali-
fied technician must install this range. Make sure
you have everything necessary for correct installa-
tion. It is the responsibility of the installer to comply
with the installation clearances specified on the
oven model/serial rating plate. This plate is located
on the frame behind the storage door panel. IM-
PORTANT: Be sure to observe all governing codes
and ordinances. In the absence of local codes,
installation must conform with American National
Standard, National Fuel Gas Code ANSI Z223.1 —
latest edition*.
* American Gas Association
1515 Wilson Boulevard
Arlington, Virginia 22209
The dimensions of the range are shown below.
Check the location where the range will be in-
stalled. The location should be away from strong
draft areas, such as windows, doors, and strong
heating vents or fans. The range should be located
for convenient use in the kitchen.
ALL OPENINGS IN THE WALL OR FLOOR ARE
TO BE SEALED AFTER THE RANGE IS IN-
STALLED.
MOBILE HOME INSTALLATION
The installation of this range must conform with the
Manufactured Home Construction and Safety Stan-
dard, Title 24 CFR, Part 3280 (formerly the Federal
Standard for Mobile Home Construction and Safety,
Title 24, HUD, Part 280), or when such standard is
not applicable, the Standard for Manufactured
Home Installations, ANSI A225.1/NFPA 510A, or
with local codes.
When this range is installed in a mobile home, it
must be secured to the floor during transit. Any
method of securing the range is adequate as long
as it conforms to the standards listed above.
Copies of standards listed may be obtained from:
INSTALLATION HIGHLIGHTS
24-13/16
"
27-1/8
"
depth
with handle
National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
29-7/8
"
width
36
"
cooktop
height
46-7/8
"
overall
height