6.
9.
Push the Start/Enter pad. DELAY and BAKE
will light up in the display to indicate that the
oven is programmed to start at a later time.
NOTE: The display will show “door” and a
tone will sound once a minute for 5 minutes if
the door ls latched when you try to bake/
roast.
You can change the temperature or time
settings any time after pushing the Start/Enter
pad without pushing the Start/Enter pad
again.
When the start time is reached, a one-second
tone will sound and DELAY will go off. The
display will show the set cook time. Lo’,
HEAT, TIMED and BAKE will light up in the
display to show that the oven is heating. The
display will count down the baking/roasting
time in minutes.
10. When the bakfng/roasting time is corqleted,
the oven will turn off automatically, beep four
times and ‘End’ will show in the display. You
will also hear four 1 -second tones every
minute until you push the Off/Cancel pad.
NOTE: To disable reminder tones, push and
hold the Cook Time pad for 4 seconds. To
reactivate tones, repeat this procedure.
To cancel the MEALTlMER”,control setting:
l Push the Off/Cancel pad to return the display to
the time of day.
Method 2-Using Start Time
and Stop Time:
1. Position the oven rack(s) properly and put food
in the oven.
2. Make sure the clock is set to the correct
time of day. (See setting the clocK on
page 12.1
3. Push the Bake pad to enter the Bake mode.
Use the Temp pad(s) to set the desired
temperature. Push A to raise the temperature
or V to lower the temperature in 5°F incre-
ments. Use these pads until the desired
temperature shows in the small display.
After you have set the desired temperature,
the display will show the set temperature and
the time of day. BAKE will light up.
22