Whirlpool RF396PXY Range User Manual


 
Using Your Range
In This Section
P&P
Using
the ourface units
.....................................
.7
Positioning
rack8 and
pans ..............................
.9
For best
air circulation
.....................................
10
Using
duminum foil
for baking.. ....................
.10
The dectronic oven controls
...........................
11
6etthg
the clock ...............................................
12
Using
the electronk
Minute Timer.. ...............
.12
Using
the Off/Cancel
pad .................................
13
Audible signals
.................................................
13
Bakinglroasting
................................................
14
Page
Adjusting the oven temperature control
....... .15
Broiling ..............................................................
16
Broiling tips .......................................................
17
Energy saving tips
............................................
17
Using the electronic MEALTIMER” control
.. .16
The oven vent
...................................................
26
The rtoraga drawer
.........................................
.27
The anti-tip bracket
..........................................
27
Optional door panel pat
..................................
27
To obtain the best cooking results possible, you must operate your range properly. This section gives
you important information for efficient and safe use of your range.
Using the
surface
units
Control knob8 must be pushed in before
turning them to a setting. They can be set
anywhere between HI and OFF.
Surface unit markers
The solid dot in the surface unit marker shows
which surface unit is turned on by that knob.
Surface unit indicator lights
One of the Surface Unit Indicator Lights on the
control panel will glow when a surface unit is on.
Hot surface indicator lights
The Hot Surface Indicator Lights on the cooktop
surface will glow when the surface units get hot.
The Indicator Lights will continue to glow as long
as the surface units are too hot to touch, even
after they are turned off.
Burn and Fire Hazard
Be sure all control knobs are turned to OFF
and all indicator lights are OFF when you
are not cooking.
Someone could be burned or a fire could
start if a surface unit is accidentally left ON.
NOTE: The surface elements may smoke slightly
and emit a burning odor during the first few hours
of use. This is normal. It is caused by the
insulation material of the new ceramic cooktop
elements and will not occur again.