Whirlpool WRF993FIFM Refrigerator User Manual


 
24
Dispensing
Touch CUBED ICE or CRUSHED ICE for your ice selection.
NOTES:
For crushed ice, cubes are crushed before being dispensed.
This may cause a slight delay when dispensing crushed ice.
Noise from the ice crusher is normal and pieces of ice may
vary in size.
When changing from crushed to cubed, a few ounces of
crushed ice will be dispensed along with the rst cubes.
Dispensing Water
IMPORTANT:
Dispense at least 1 qt (1 L) of water every week to maintain a
fresh supply.
If the ow of water from the dispenser decreases, it could be
caused by low water pressure.
With the water lter removed, dispense 1 cup (237 mL) of
water. If 1 cup (237 mL) of water is dispensed in 8 seconds
or less, the water pressure to the refrigerator meets the
minimum requirement.
If it takes longer than 8 seconds to dispense 1 cup
(237 mL) of water, the water pressure to the refrigerator
is lower than recommended. See “Water Supply
Requirements” and “Troubleshooting” sections for
suggestions.
To Dispense Water - Standard:
1. Press a sturdy glass against the water dispenser paddle.
2. Remove the glass to stop dispensing.
NOTE: The Measured Fill button does not enable standard
dispensing. It only functions in Measured Fill mode (see below).
To Dispense Water - Measured Fill:
Measured Fill allows you to dispense a specied amount of water
with the touch of a few buttons.
1. Put a sturdy glass under waterspout. Touch MEASURED FILL
to activate.
NOTE: The amount of water you select will be dispensed. Make
sure the container can hold the entire volume. If ice is in the
container, you may need to adjust your selection.
2. Touch MEASURED FILL to turn on, then touch to select
8 oz (0.2 L), 16 oz (0.5 L), or 24 oz (0.7 L). Touch a fourth
time to exit Measured Fill display.
3. Touch FILL (center ring button) and the selected amount of
water will be dispensed.
NOTES:
The Measured Fill dispenser will automatically time out after
1 minute of inactivity.
You can rell several glasses with the same measurement
by continuing to touch FILL (center ring button) after each
glass ll.
Measured Fill Options are listed in the following chart:
Units
Ounces 8 16 24
Cups 1 2 3
Liters 0.2 0.5 0.7
NOTES:
Most coffee cups (commonly 4 to 6 oz [118 to 177 mL] per
cup) are not the same size as a measuring cup (8 oz [237 mL]).
You may need to recalibrate Measured Fill to underll or to
avoid unintentionally overlling coffee cups.
4. Dispense water.
NOTE: While dispensing water, the center light circle will fill
in. The flow of water will automatically stop once the desired
volume has been dispensed.
Press a sturdy glass against the dispenser paddle below
the water spout.
OR
Place the glass below the waterspout and touch FILL for
hands-free dispensing.
5. To stop dispensing before the selected volume has been
dispensed, touch FILL a second time or touch the water
dispenser paddle.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the center light circle will continue to reflect
how much water remains to be dispensed. The display will
turn off after 1 minute of inactivity.
6. To select a new volume or start dispensing the same volume
again, you must rst nish dispensing the selected volume or
turn off the Measured Fill feature (either by waiting 1 minute
so it will automatically turn off or by touching CUBED ICE
or CRUSHED ICE to manually turn it off), and then select
Measured Fill again.