Filter
Top Products
12
TIMER OPERATION
The control panel of the steamer module has
an independent 99-minute timer. Refer to the
i
llustration below. This function can be used
with or without the unit in operation. However,
the steamer must not be in
Lock mode
.
To start the timer, touch the ”
+
” or ”
–
”
s
ymbol until the correct amount of time is
shown in the timer display. The timer will
begin its countdown after a 2 second delay.
A warning beep will sound when the timer
has 1 minute left and begins to countdown
in seconds starting at 59.
A signal will beep when time has expired
and will continue to beep every 30 seconds.
Touch to reset the timer.
WOLF STEAMER MODULE USE & CARE
Timer controls
Timer
display
AUTOMATIC DRAIN OPERATION
IMPORTANT NOTE:
The steamer module
must be installed with a drain connection and
a
ccess to the drain through the base cabinet.
T
he touch pad operation is functional
only while the unit is in
Idle mode
. The unit
must be unlocked and not in operation. Refer
t
o the illustration below.
To activate the drain:
1)
Touch for 3 seconds. The unit will
beep, the light in the touch pad will
illuminate and the drain valve will open for
a period of 2 minutes. This should be
enough time to drain a full capacity of
water. This operation may be repeated as
many times as needed to completely drain
the steamer basin.
2)
Touch again while in the drain
mode operation to shut the drain valve. The
light in the touch pad will go out.
If you do not have a fixed drain connec-
tion, use caution when draining hot water
from the steamer basin to avoid burns.
Use a heat-resistant receptacle with a
minimum 7.6 L capacity. The doors of the
base cabinet must be locked.
Touch control panel
touch pad
touch pad
”+” and ”–”
symbols