Filter
Top Products
STEAMER MODULE OPERATION
BEFORE USING FOR THE FIRST TIME
C
lean your steamer module thoroughly with
hot water and a mild detergent. Rinse and dry
with a soft cloth. This removes any residual oil
a
nd grease left on the surface from the manu-
facturing process.
Refer to Care Recommendations on page 15.
Apply a stainless steel polish to protect the
finish and add luster.
During the initial period of use, you may smell
a light burning odor or see light smoke. Both
these conditions are normal with a new
cooktop module.
10
MODES OF OPERATION
LOCK MODE
I
n
L
ock mode
,
all touch pad operations on
the control panel are disabled and the heating
element is deenergized. A steady glowing light
i
n the touch pad indicates that the unit
is locked. Refer to the illustration below for
location of the touch pad.
To lock the control panel, touch and hold
the symbol for 3 seconds. The unit
will beep three times and the light in the
touch pad will illuminate. The
control unit is now in
Lock mode
.
To unlock the control panel, touch and hold
the symbol for 3 seconds. The unit
will beep twice and the light in the
touch pad will go out. The control unit is
now in
Idle mode
.
IMPORTANT NOTE:
When the unit is powered
up for the first time or if there has been a
power outage, the steamer module will default
to
Lock mode
.
IDLE MODE
After unlocking the control panel as described
in Lock Mode, the unit enters the
Idle mode
of
operation. The valid touch pad operations are
, ,, ”
+
” or ”
–
” and the
Lock mode
.
WOLF STEAMER MODULE USE & CARE
Water or liquid must be added to the
steamer basin before turning the unit on.
Serious injury or damage to the steamer
module may result when pouring liquid
into a heated steamer basin.
Do not use abrasive cleaners; they will
permanently scratch the surface.
T
emperatur
e
LED display
Lock ”key”
touch pad
Power indicator
bar graph
DRAIN
touch pad
T
emperatur
e
adjustment
OFF ON
touch pad
T
imer LED
display
CLEAR
touch pad
Touch control panel