Filter
Top Products
56
FIRST USE
FILL THE WATER TANK
• Open the unit clamping lock (ref.24) using the key
supplied.
• Pull the coffee machine out of the unit on the
telescopic runners.
• Fill the water tank (ref.27) located on the left-hand
side of the appliance with approx. 3 litres of water.
• Push the machine back into the unit and fasten the
unit clamping lock.
• Water hardness:
- before filling the water tank make sure that the
Brita filter is in place (see paragraph "Water
supply").
- if the appliance has not been used for a long time it
is advisable to replace the water in the tank with
fresh water and to empty the boiler by pressing the
coffee button (ref.4) repeatedly.
FILL THE COFFEE BEAN HOLDER
• Open the unit clamping lock (ref.24) using the key
supplied.
• Pull the coffee machine out of the unit on the
telescopic runners.
• Pour approx. 200g of coffee beans into the coffee
bean holder (ref.26) on the right-hand side of the
appliance.
• Push the machine back into the unit and fasten the
unit clamping lock.
ADJUSTING THE TEXTURE OF
GROUND COFFEE
• The machine is supplied already calibrated to
grind coffee beans to the ideal texture.
• The texture of ground coffee can however be
adjusted using the grinding texture knob (ref.2).
Turn the knob clockwise for a finer texture
and stronger coffee. Turn anticlockwise for
a coarser grind and weaker coffee.
PROGRAMMING THE QUANTITY
OF GROUND COFFEE
• The machine is supplied already
calibrated to supply the ideal dose of
ground coffee for a cup of espresso.
• However, the quantity of ground coffee
supplied can increased or decreased as
follows:
place the filter holder (ref.20) with a one-
cup filter (ref.21) below the coffee doser
outlet (ref.19) and press the grinder button
(ref.18) gently, do not release the button
immediately. After approx. 10 seconds the
grinder will start, when the quantity
required is reached (recommended dose 7g
corresponding to 6 seconds of grinding)
simply release the button (ref.18) and the
dosage is automatically programmed.
PRELIMINARY START-UP
• Turn the coffee machine on by pressing the
ON button (ref.3). The orange indicator
light (ref.8) lights up to indicate that the
machine is powered.
• Turn the steam knob (ref.1) anti-clockwise.
• Press the hot water button (ref.5) and wait
until all the air in the boiler is released
through the steam spout (ref.16) and water
starts coming through.
• The red indicator light (ref.9) lights up at
the same time to indicate that the water in
the boiler is being heated. When the red
indicator light goes out the water has
reached the required temperature for coffee
making.
• Close the steam knob (ref.1) and release
the hot water button (ref.5).