2-17
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 2 Content Switching Module with SSL Commands
heartbeat-time (fault tolerant submode)
heartbeat-time (fault tolerant submode)
To set the time interval between heartbeat messages that are transmitted by the CSM, use the
heartbeat-time command in the SLB fault-tolerant configuration submode. To restore the default
heartbeat interval, use the no form of this command.
heartbeat-time heartbeat-time
no heartbeat-time
Syntax Description
Defaults Heartbeat time is 1 second.
Command Modes SLB fault-tolerant configuration submode
Command History
Examples This example shows how to set the heartbeat time to 2 seconds:
Cat6k-2(config-slb-ft)# heartbeat-time 2
Related Commands ft group
show module csm ft
heartbeat-time Time interval between heartbeat transmissions in seconds; the range
is from 1 to 65535.
Release Modification
CSM release 1.1(1) This command was introduced.
CSM-S release 1.1(1) This command was introduced.
