- 155 -
ccc: Left offset
000 to 719 (in dots)
ddd: Top offset
000 to 719 (in dots)
eee: Character width
001 to 720 (in dots)
fff: Character height
001 to 720 (in dots)
ggg: Horizontal spacing/proportional spacing
000 to 999 (in dots)
h: Type of writable character data
0: Nibble mode (4 bits/byte)
1: Hex. mode (8 bits/byte)
iii --- iii: Writable character data to be stored
* If each parameter for left offset, top offset, character width, character height, and
horizontal spacing/proportional spacing is fixed as “000”, the setting is ignored when
the writable character set is 41 to 44,
Explanation (1) Type of writable character
Up to 44 and 49 writable character sets can be stored for the flash card and the
ATA card, respectively. However, the maximum number of characters varies
depending on the writable character size and the number of characters because of
the limited memory capacity. For writable character sets, 41 to 44, each writable
character size is fixed.
(2) Character code
Up to 224 characters can be stored per character set. The maximum number of
characters is 40 sets × 224 characters = 8960 characters. It varies depending on
the writable character size and the number of characters because of the limited
memory capacity. For character sets, 41 to 44, a character code consisting of 1
byte is stored. However, when the character code is called up, F0H is added to
the upper digit of it, and consists of 2 bytes. In this case, up to 188 characters can
be stored per character set.
(3) Only a 4-MB flash memory card can be used for storing a writable character.
