- 202 -
9.2 PARALLEL INTERFACE
9.2.1 Compatible Mode
LCD Messages Printer Status Output Signal
Busy Select nFault PError
ON LINE
In the online mode L H H L
ON LINE
In the online mode (communicating) L, H H H L
HEAD OPEN
The head was opened in the online mode. H L L L
PAUSE ****
In a pause state H L L L
ON LINE
Data was set from the host with the receive
buffer full.
HHHL
ON LINE
After data was sent from the host with the
receive buffer full, some data is processed and
room becomes available.
LHHL
ON LINE
Initialize process in execution (After the power
is turned on or nInit is received)
HLLL
Display of error command
A command error has occurred in analyzing
the command.
HLLL
PAPER JAM ****
A paper jam occurred during paper feed. H L L L
CUTTER ERROR****
An abnormal condition occurred at the cutter. H L L L
NO PAPER ****
The label has run out. H L L H
HEAD OPEN ****
A feed or an issue was attempted with the
head opened. (except the [FEED] key)
HLLL
HEAD ERROR
A broken dot error has occurred in the thermal
head.
HLLL
EXCESS HEAD TEMP
The thermal head temperature has become
excessively high.
HLLL
RIBBON ERROR****
An abnormal condition occurred in the sensor
for determining the torque for the ribbon motor.
The ribbon has run out.
HLLL
SAVING ### &&&&
In writable character or PC command save L H H L
SAVING %%%%%%%
mode
FLASH WRITE ERR.
An error has occurred in writing data into the
flash memory card.
HLLL
FORMAT ERROR
An erase error has occurred in formatting the
flash memory card.
HLLL
FLASH CARD FULL
Saving failed because of the insufficient
capacity of the flash memory card.
HLLL
POWER FAILURE
A momentary power interruption has occurred. H L L L
EEPROM ERROR
An EEPROM for back-up cannot be
read/written properly.
HLLL
