- 20 -
• Centronics ACK/BUSY timing setting
• TYPE1
• TYPE2
• Web printer function setting
• ON (Web printer function is enabled.)
• OFF (Web printer function is disabled.)
• Silent printing function setting
• ON (Silent printing function is enabled.)
• Keyboard (KB-80) connection setting
• ON (The keyboard is connected.)
• OFF (The keyboard is not connected.)
(3) Various fine adjustment value settings
• Feed fine adjustment (± 50.0 mm)
• Cut position (or stop position of the strip issue) fine adjustment (± 50.0 mm)
• Back feed fine adjustment (± 9.5 mm)
• X-coordinate fine adjustment (± 99.5 mm)
• Print density fine adjustment
(Thermal transfer/Direct thermal print modes) (± 10)
• Lower reflective sensor manual threshold fine adjustment (0.0 V to 4.0 V)
• Transmissive sensor manual threshold fine adjustment (0.0 V to 4.0 V)
• Ribbon motor drive voltage fine adjustment (Rewind) (-15 to +6)
• Ribbon motor drive voltage fine adjustment (Back tension) (-15 to +10)
(4) Test print
(5) Sensor display/adjustment
• Thermal head temperature sensor display
• Open-air temperature sensor display
• Heat sink sensor display
• Upper reflective sensor display/adjustment
• Lower reflective sensor display/adjustment
• Transmissive sensor display/adjustment
• Lower reflective sensor adjustment value setting (without paper)
• Transmissive sensor adjustment value setting (without paper)
(6) RAM clear
• Maintenance counter clear
• Parameter clear
(7) IP address setting
• Printer IP address
• Gateway IP address
• Subnet mask
