Filter
Top Products
System Administrator’s Guide U42252-J-Z915-1-76
NSR-ORA and NetApp Recovery
The saveinfo.sh command is not relevant to the NDMP backup method,
and it will not be started after the backup has completed. If the backup
process has been performed successfully you will be informed by the
savegrp completion notification.
6.5.3 Debugging
To enable debugging functions NSR-ORA creates a number of files within the
/nsr/oracle/{ORACLE_SID}/prot/dbg directory for every backup performed. In this
directory you can find records of the communication between NSR-ORA and
the NetApp filer, between NSR-ORA and Networker and, finally, between NSR-
ORA and Oracle. If any problems occur during the communication it is recom-
mended to send a copy of the relevant record file to your IT service.
6.6 Recovery with NSR-ORA
In general there are no syntax changes to the commands of the recovery
process from NSR-ORA V3.1B to the newer version 3.2. This section describes
the processes and procedures involved in performing a recovery of NetApp
backups.
6.6.1 Recover until time (ora_recut)
Performing a Recover until time NSR-ORA checks, whether there is a snapshot
preceding the specified time. Later you will be asked to decide to use this
snapshot or an respective tape backup for the recovery.
Example:
ora_recut -t 2001-07-27:16:55:00 NET816
Which saved Version do you want to use
1) the Snapshot from <Jul 27 16:46 nsrora_NET816_actual>
2) the tape version from <Jul 27 16:38
nsrora_NET816_NDMP_ONLINE>
(default 1:) >
i