Filter
Top Products
11
Installation and Set-Up (Continued)
Figure 2-1 – 700r Frame Set-Up
9. Cut and remove cable ties on both upper and
lower taping heads. (Applying/buffing rollers are
held retracted for shipment.)
Hold taping head BUFFING ROLLER and cut
and remove cable tie that holds applying/buffing
arms retracted. See Figure 2-1C. Allow buffing/
applying arms to extend slowly.
Also cut and remove cable tie at rear of lower
taping head.
CAUTION – Follow this step carefully
as spring pressure is applied to
applying and buffing arms when cable tie
is removed. Keep hands/fingers AWAY
from tape cut-off knife under orange knife
guard. Knife is extremely sharp and can
cause severe injury.
10. Check for free action of both upper and lower
taping heads.
WARNING – Keep hands/fingers
away from tape cut-off knife under
orange knife guard. Knife is extremely
sharp and can cause severe injury.
Push buffing roller into head to check for free,
smooth action of taping heads.
11. Ensure that the tape drum bracket assembly,
located on the lower taping head, is mounted
straight down, as shown in Figure 2-5A. The
tape drum bracket assembly can be pivoted to
provide tape roll clearance in certain cases.
12. Remove fasteners that secure case sealer legs
to pallet.