Filter
Top Products
26
Adjustments (Continued)
WARNING – Turn off electrical power and air supply and disconnect power cord from electrical
supply before beginning adjustments. If power cord is not disconnected, severe injury to
personnel could result.
Refer to Figure 5-2 and 5-3 and adjust belt tension as follows:
1. Remove and retain center plates/front cover and four screws.
2. Loosen, but do not remove, M10 lock nut with a 17 mm open end wrench.
3. Reset the tension on the drive belts as needed. Adjust the M8 tension screws in (clockwise) to increase
tension or out (counterclockwise) to decrease tension. Tighten lock nut to secure tension setting.
4. Replace center plates/front cover and secure with original screws.
Figure 5-2 – Box Drive Belt Tension Adjustment, Lower Belts (Infeed End)