Filter
Top Products
FPC 8084 Users Manual
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first, second and
twist serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART 2 Mode
This item a is to select UART mode. By default, this field is set to
Standard.
IR Function Duplex
This item is to select the IR half/full duplex function.
TX,RX inverting enable
This item is to enable the TX, RX inverting which depends on different
H/W requirement. This field is not recommended to change its default
setting for avoiding any error in the system.
Onboard Serial Port 3
This item allows you to determine access onboard serial port 3 with
which I/O address. The options available are
3F8H/2F8H/3E8H/2E8H/Disabled.
Serial Port 3 Use IRQ
Select an corresponding interrupt for the 3
rd.
serial port. The options
available are IRQ10/11/3/4/5/7/9.
Onboard Serial Port 4
This item allows you to determine access onboard serial port 4 with
which I/O address. The options available are
3F8H/2F8H/3E8H/2E8H/Disabled.
Serial Port 4 Use IRQ
Select an corresponding interrupt for the 4
th
. serial port. The options
available are IRQ10/11/3/4/5/7/9.
Onboard Parallel Port
This item is to determine access onboard parallel port controller with
which I/O address.
The choice: 3BC/IRQ7, 378/IRQ7, 278/IRQ5, Disabled.
Onboard Parallel Mode
Select an operating mode for the onboard parallel (printer) port. Select
Normal, Compatible, or SPP unless you are certain your hardware and
software both support one of the other available modes.
The choice: SPP, EPP, ECP, ECP+EPP.
ECP Mode Use DMA
51