Filter
Top Products
17
Changing Oven Light
The oven light automatically turns on when the door is
opened. To turn the oven light on and off when the door is
closed, use the
OVEN LIGHT
switch located in the control
panel.
The oven light bulb is located at the rear of the oven. To
replace, follow these instructions:
CAUTION
!
To avoid risk of personal injury, be sure the oven is
unplugged and all parts are COOL before replacing the
oven light bulb.
1. Turn electrical power off at the main source or unplug the
oven. BE SURE ALL PARTS ARE COOL BEFORE
REMOVING BULB.
2. Wear a leather-faced glove for protection against pos-
sible broken glass.
3. Press wire holder to one side to release the glass shield.
Figure 14—Oven Light Cover
4. Replace bulb with a new 40 watt appliance bulb.
5. Replace glass shield in socket and snap wire holder into
place.
6. Turn power back on again at the main source (or plug
the oven back in).
7. Clock needs to be reset. Follow instructions in
“Programming” under “Set Clock”.
Adjusting Oven Temperature
The temperature in the oven has been calibrated at the
factory. When first using the oven, be sure to follow recipe
times and temperatures. If you think the oven is too hot or too
cool, the temperature can be adjusted. Before adjusting the
oven temperature, test a recipe by using a temperature set
higher or lower than the recommended temperature. The
baking results should help you to decide how much of an
adjustment is needed.
1. Press
BAKE (MODE)
pad.
2. Press or pad to set temperature to 550°F/
288°C.
3. Within 2 seconds, press and hold
BAKE
pad for
approximately 5 seconds until the special 2 digit
display appears. Release the BAKE pad.
• Display indicates the difference in degrees between
the original factory temperature setting and the
current temperature setting. If the oven control has
the original factory calibration, the display will read
"00."
4. Press or pad to adjust temperature 35°F/17°C,
in 5°F/1°C increments.
• Adjust until the desired amount of offset appears in
the display. A minus sign (-) appears before the
number to indicate the oven will be cooler by the
displayed amount of degrees.
5. Press
OVEN CANCEL
pad to go back to the time of
day display.
Cleaning Wall Oven Parts
Before cleaning any part of the wall oven, be sure all
controls are turned “OFF” and the oven is COOL.
REMOVE SPILLOVERS AND HEAVY SOILING AS
SOON AS POSSIBLE. REGULAR CLEANING WILL
REDUCE THE NUMBER OF MAJOR CLEANING LATER.
CAUTION
!
To avoid risk of personal injury, before cleaning any
part of the oven, be sure the electronic oven control is
turned off or press
OVEN CANCEL
pad. Wait until the
oven is cool.