Filter
Top Products
7
Adjusting Oven Height
Oven height can be adjusted when needed to fit into an
existing cabinet cutout opening. To adjust oven height:
1. Lay the oven on its back.
2. Remove the 6 screws fastening the side of each
extension panel to the bottom sides of the oven.
3. Move each panel down to the position that increases
the oven height to fit the existing cutout opening.
Each position changes oven height approximately
1
/2 inch up to 2 inches.
4. Line up the appropriate holes in the side extension
panels and sides of the oven. Replace the 6 screws.
5. Proceed with oven installation. Return oven to upright
position.
Oven door
Extension panel
Oven bottom
Figure 5 – Extension Panel
Cabinet Installation
CAUTION
!
Do not lift the oven by the door handle. Preferably,
remove the oven door to facilitate handling and prevent
damage to the appliance.
Slide the oven all the way into the cabinet opening.
Check for level installation with a level on the oven rack.
In wood cabinets, drill
1
/8-inch pilot holes for No. 10 wood
screws through the mounting holes in the front frame.
Then mount the oven to the cabinet with the screws
furnished.
Locate lower grill assembly and trim adaptors that were
removed during unpacking. Carefully break apart the trim
adaptors and insert them in each side of the lower grill
assembly. Insert the protruding end of the trim assembly
into the oven side trim, sliding the assembly up from the
bottom. Secure the grill assembly to the cabinet with the
two Fillister screws provided.
2" Fillister screw
Slide and fit lower
g
rill assembl
y
into oven side trim
Fit trim adapter
(one each side)
Figure 6
Checking Operation
Upon completion of the electrical hookup, the operation of
the electronic oven control should be verified. The Bake,
Broil, and Clean modes should be checked by operating
the electronic control according to the instructions
contained in this manual .