Filter
Top Products
Machine Compartment Disassembly Procedures
RS1200001 38 November 1996
Condensate Drain Pan
1. Remove toe grille plate by removing screws.
2. Pull drain pan forward away from condenser.
Condenser
1. See Compressor, Condenser, Condenser Fan
Access.
2. See Condenser Fan Motor, steps 1-3.
3. Remove three 1/4" hex head screws that mount
condenser to machine compartment floor.
4. Score capillary tube at drier and break.
5. Unbraze condenser inlet.
6. Slide condenser assembly out.
7. Unbraze 3/16" copper tube from condenser to
drier to be reused on replacement condenser and
drier.
Power Disconnect Switch
1. See Machine Compartment Access.
2. Remove leads.
3. Pop switch out through front.
Showroom Switch
1. See Low and High Voltage Board and Showroom
Switch Access.
2. Remove screws and pull switch down.
3. Remove leads.