Filter
Top Products
Installation
STEP 3: PREPARE THE VENTING BLOWER
I ,,w.....o iI
ELECTRICAL SHOCK HAZARD!
UNPLUG UNIT BEFORE WORKING ON IT.
• DO NOT PULL OR STRETCH THE BLOWER WIRING!
Pulling and stretching the blower wiring could result in electrical shock.
Your microwave oven is shipped with the blower assembled for roof venting. If you want wall-venting or
room-vented (recirculating) installation, you must change the fan, as detailed below.
Remove two screws that attach mounting plate to microwave
oven cabinet. See Figure 10.
Remove mounting plate and set aside. Discard the screws.
ROOF-VENTED INSTALLATION:
Go to STEP 4.
WALL-VENTED INSTALLATION:
1. Remove one blower unit mounting screw and two blower plate
screws. Remove the blower plate from cabinet.
See Figure 11.
2. Carefully liftthe blower unit out of the microwave oven.
3. Use side cutters or tin snips to cut and remove knockouts part
"B" from Back plate. Discard knockouts.
Be careful not to distort the plate. See Figure 12.
4. Pull out the blower wire from wire clip, and put blower wire in
another clip. See figure 13.
5. Rotate the unit sothat the exhaust ports face the rear of the
cabinet. See Figure 14. When you insert blower unit, blower
wire must be like figure 14.
6. Place blower unit back into cabinet. Check that the exhaust
ports face towards the rear of the cabinet.
See Figure 15.
7. Reattach the blower plate to cabinet so the exhaust ports and
blower plate opening are aligned. Attach with one blower unit
mounting screw and then two blower plate mounting screws.
See Figure 16.
Replace screws
intocabinet.
Remove
plate.
Figure 10
blower back plate
unit
lower plate
mounting screws
blower unit
mounting screw
Figure 11
Figure 13D
__Parts "B" Knockouts Pans "e"
unit
exhaust
ports
Figure 14
- 39 -