Filter
Top Products
Installation
STEP 6: ATTACH THE OVEN TO THE WALL
L _1= WARNING
You will need two people to lift this microwave.
Failure to use more than one person could
result in personal injury.
1. Carefully lift microwave oven and hang it on support tabs
(See Figure 28 at the bottom of the mounting plate. Reaching
through upper cabinet, thread power supply cord through the
power supply cord hole in the bottom of the upper cabinet.
See Figure 32.
2. Rotate the microwave upward so the top of oven is against
the bottom of the upper cabinet or cabinet frame.
Figure 32
3. Drop the lock pin and washer assembly into hole N (left
side hole) and push the pin down as far as it will go.
See Figure 33.
4. Place washers over two 1/4"x3" bolts. Then insert a bolt
down through each hole in the upper cabinet bottom.
Tighten the bolts until the gap between the upper cabinet
and microwave oven is closed. See Figure 34.
5. Remove the lock pin and washer.
If wall-vented or room-vented installation is used, skip to
No. 8.
Figure 33
Figure 34
-44-