Filter
Top Products
A7 RS2320006 Rev. 0
Important Safety Information
SAVE THESE INSTRUCTIONS
WARNING
!
To avoid risk of the appliance tipping, it must be secured by a
properly installed anti-tip bracket. To make sure bracket has been
installed properly, remove the storage drawer or panel and look
under the range with a flashlight. Bracket must be engaged in the
rear corner of the range.
Ó 2001 Amana Appliances
Amana, Iowa 52204
Part No. 36-32055801-0
Printed in U.S.A. 03/01
WARNING
!
To avoid risk of burns or fire by
reaching over elements, cabinet
storage space located above
range should be avoided. If
cabinet storage is provided,
install a range hood that projects
horizontally a minimum of 5"
beyond the cabinet bottom to
reduce the risk.
WARNING
!
To avoid risk of electrical shock,
personal injury, or death, make
sure your range has been
properly grounded and always
disconnect it from main power
supply before servicing.
ALL RANGES CAN TIP
INJURY TO PERSONS
COULD RESULT
INSTALL ANTI-TIP
BRACKET(S) PACKED
WITH RANGE
SEE INSTALLATION
INSTRUCTIONS
Minimum Clearances to Combustible Surfaces
This range can be installed flush against right and left base
cabinets, and rear vertical wall. Range can also be installed
flush against left or right vertical wall extending above 36"
standard countertop height. The dimensions provided are
to be measured from the range itself, and not the
installation cutout for the range.
AMinimum of 30" between top of cooking surface and
bottom of an unprotected wood or metal cabinet.
OR
AMinimum of 24" between cooking surface and wood or
metal cabinet bottom protected by not less than ¼" thick
flame retardant millboard covered with not less than No. 28
MSG sheet steel, .015 inch thick stainless steel, .024 inch
thick aluminum, or .020 inch thick copper.
BMinimum of 30" of protected cabinets above the range
(refer to letter A)
CMinimum of 18" between top of countertop and bottom of
an unprotected wood or metal cabinet.
DMaximum depth of 13" for overcounter cabinets.
&
%
$
'