Filter
Top Products
6-1h. Replacing the power cord for a CA43.
Required: Medium (6”) phillips screwdriver, Medium (6") flathead
screwdriver, Wiring markers (color or number codes), Electrical tape ,
Wiring diagram for CA43(see step 10)
1. Remove the back panel of the module by removing the five
phillips head screws and gently lifting out the back panel. Lay
the panel on a clean work surface. (Fig. 22)
Figure 20
Figure 21
Figure 22
Diagram 2
2. Mark all the wires connected to the power cord with a color
code or number to make proper re-connection easy. (Fig. 23)
3. Free the green ground wire by grasping the nut with fingers or
pliers (inside the back panel of module) and remove screw
from the outside surface of the panel with a medium (6")
phillips screwdriver. (Fig. 24)
4. Free the other two power cord wires by removing the two wire
nuts they are attached to.
5. Remove elbow connector that secures power cord onto the
back panel. While grasping the nut (on the inside surface of the
panel) and holding the connector (on the outside surface of the
panel), rotate the nut to loosen and remove the elbow from the
panel. (Fig. 25) .
6. Remove the two screws that secure the power cord into the
compression end of the elbow connector with a medium (6”)
flathead screwdriver. Pull gently to free power cord from the
elbow connector. (Fig. 26)
7. Insert new power cord into elbow connector and replace
compression screws. Tighten screws to secure power cord
into connector.
Replace only with a BEVLES power cord
properly rated for your unit.
8. Insert new wires through opening in back panel and reattach
elbow connector.
9. Reattach green ground wire to back panel.
10. Reconnect power cord wires using wire nuts and wiring
diagram. Retape over wire nuts and wires. (Diagram 3)
Severe damage can be caused to your unit by
improperly connecting wires.
11. Replace the back panel using the five phillips head screws.
*"WARNING:
**WARNING:
Figure 23