Filter
Top Products
909A & 919A OWNER/OPERATOR MANUAL • 9
MANUAL OPERATION
Note: Make sure on the Model 919A slicers that the shift lever is in the manual position.
1. Turn the unit on by pushing the START switch up, then release so that it goes back to the middle
position. The knife will start slowly, then speed up.
WARNING
THE PRODUCT TABLE HANDLE IS THE ONLY PART OF THE
SLICER YOU SHOULD EVER TOUCH WHILE SLICING.
2. Using the product table handle, slide the table back and forth. If there is any rough operation or
obstruction, shut the machine off, unplug the power cord, and call your nearest Designated Berkel
Service Location, which can be found at www.berkel.com.
3. Allow the slicer to run for 15 seconds without moving the table. The slicer should automatically turn
off after 15 seconds of non-movement of the product table. If not, call your nearest Designated
Berkel Service Location.
AUTOMATIC OPERATION
1. See General Section on Page 8.
2. With the unit OFF, push shift lever toward AUTO with left hand while sliding the product table
handle with the right hand until you feel it engage.
3. Remove your right hand from the product table handle.
4. Select LO speed by switching the speed selection switch to the DOWN position.
WARNING
THE NEXT STEP WILL CAUSE THE PRODUCT TABLE TO
MOVE AUTOMATICALLY AND THE KNIFE TO ROTATE.
5. Start the machine. The slicer will now slice approximately 40 slices per minute. Select HI speed
by switching the speed selector switch to the UPPER position. The slicer will now slice
approximately 60 slices per minute.
6. Turn the slicer OFF after testing by pushing the start/stop switch down and then pushing the shift
lever to the MANUAL position.