Filter
Top Products
909A & 919A OWNER/OPERATOR MANUAL • 19
3. Inspect the power cord? Has it been damaged, cutting off electrical flow?
4. Are you getting electricity from wall outlet? Check by plugging in another piece of equipment
with the same electrical requirements. Also, check the circuit breaker or fuse.
If you are getting electrical power, and your slicer is still not operating properly, contact your Desig-
nated Berkel Service Location.
INDEXING MECHANISM NOT ADVANCING GAUGE PLATE
1. Is the product table properly attached to the support arm? If not, the gauge plate can not be
opened.
2. Is the slicer running. You will not be able to open the gauge plate until the slicer is running.
If the indexing knob should not open and close the gauge plate properly, it is a sign that the internal
mechanism has suffered some loss of adjustment. Do not try to adjust the mechanism yourself.
Contact your Designated Berkel Service Location.
AUTOMATIC/MANUAL SELECTOR NOT ENGAGING (919A MODEL)
This should be checked only by your Designated Berkel Service Location.
NOTE: The mechanism in the undercarriage should not be oiled or greased except by a Designated
Berkel Service Location. Excess oil can lead to wear, breakage and slippage of the drive belt and
cause you needless expense.
REPAIR PARTS/REPAIR SERVICE
Please contact your Designated Berkel Service Location (DBSL) for any repair parts and/or repair
service required on your Berkel slicer. Your nearest DBSL can be found on the web at
www.berkel.com. Additional information may be obtained from:
Service Support Center
Berkel Company
4406 Technology Drive
South Bend, Indiana 46628
(574) 232-8222
(800) 348-0251