Filter
Top Products
19
Care, cleaning and guarantee continued Trouble shooting guide
Machine will not work when switched
‘ON’
The safety locking arm may not be correctly engaged
in the vertical operating position with the locking arm
located into the two grooves on either side of the
juicer cover (page 8 step 5).
Motor appears to stall when juicing
Wet pulp can build up under the juicer cover if the
juicing action is too vigorous. Try slower juicing
action by pushing the food pusher down more
slowly (page 10 step 4). Follow Disassembling
and Cleaning instructions and clean the filter bowl
surround, the juice disc and the juicer cover.
The ikon™ Froojie™ Juice Fountain
®
will
automatically stop operating if the motor is stalled
for more than 10 seconds. Either too much food
is being processed at one time or the pieces are
not small enough. Try trimming the food or cutting
into smaller pieces of even size and processing
a smaller amount per batch. To continue juicing,
reset the ikon™ Froojie™ Juice Fountain
®
by
pressing the ‘On/Off’ switch on the control panel to
‘Off’ then turn the appliance back on by pressing
‘On/Off’ switch to ‘On’.
Hard fruits and vegetables will put excess strain
onto the motor if a low speed is selected. Please
refer to the juicing guide on Page 9 to determine
the correct speed for the fruits and vegetables
selected for juicing.
Excess pulp building up in the stainless
steel filter basket
Stop the juicing process and follow Disassembling
Instructions. Remove the juicer cover, scrape off pulp,
reassemble and begin juicing again. Try alternating
(soft and hard) vegetable and fruit varieties.
1.
2.
3.
Pulp too wet and reduced
extracted juice
Try a slower juicing action.
Remove juice disc and thoroughly clean mesh walls
with a cleaning brush. Rinse the juice disc under hot
water. If the fine mesh holes are blocked, soak the
basket in a solution of hot water with 10% lemon
juice to unblock the holes or wash in the dishwasher.
This will remove excess fibre build up (from fruit or
vegetables) which could be inhibiting the juice flow.
Juice leaks between the rim of the Juicer
and the juicer cover
Try a slower juicing speed and push the food pusher
down the feed chute more slowly (page 10, step 6).
Juice sprays out from spout
Use juice jug and lid provided, or if juicing into
a glass use the custom designed juice nozzle.
Try using fruits with more water content to help
flush through the contents. Additionally, try a slower
juicing action by feeding one piece in at a time and by
pushing the food pusher down more slowly.
When using the Froojie™ Extractor, the
filter bowl surround becomes full and
clogs its spout.
Try using fruits with more water content to help
flush through the contents. Additionally, try a slower
juicing action by feeding one piece in at a time and by
pushing the food pusher down more slowly.