Filter
Top Products
130
9
9
Figure 13
3. Assemble washer (C, Figure 14) to puller
screw (D) and insert through large end of
removal driver (B). Place open end of
support (A) against ball bearing.
4. Insert screw with washer and driver
through ball bearing and thread into
support. Continue tightening screw until
ball bearing is removed.
Figure 14
5. Lubricate outside diameter of new ball
bearing. Place ball bearing on support (A,
Figure 15).
6. Assemble washer (C) to puller screw (D).
Insert large end pilot (B) into oil seal boss
in crankcase cover.
7. Insert screw through pilot and thread into
support. Tighten screw until ball bearing is
seated.
8. Install new oil seal. Use large end of Driver
#19320, and press in oil seal until flush
with crankcase cover.
9. Install governor idler gear and E-ring.
Figure 15
NOTE: Always install new oil seals when engine
is reassembled or when replacing bearings.
Always use the correct seal protector to prevent
damaging the oil seal during installation.
Replace Ball Bearing
Horizontal Models 200000, 210000
1. Select tools needed from charts below.
2. Remove retaining ring and governor idler
gear. Remove oil seal.
3. Assemble washer (C, Figure 16) to puller
screw (D) and insert through small end of
removal driver (B). Place open side of
support (A) against ball bearing with
cutout over idler gear shaft.
Bearing Removal Tools
Tool/Part
Description
Tool/Part #
Washer 690582
Puller Screw 19318
Removal Driver 19401
Removal Support 19440
Bearing Installation Tools
Tool/Part Description Tool/Part #
Washer 690582
Puller Screw 19318
Installation Driver 19396
Installation Support 19394