Filter
Top Products
Page 22
Location:
The control thermostat is located inside the lower
left front of the brewer on the component bracket.
1. Disconnect the brewer from the power source.
2. Locate the blue wires on the control thermostat.
3. With a voltmeter, check the voltage across the blue
wires on the control thermostat and the white
insert on the two or three pole 120V, 120/208V,
120/240V terminal block and the red insert on two
pole 200V or 240V terminal blocks. Connect the
brewer to the power source. The indication must
be:
a.) 120 volts ac for two wire 120 volt models, three
wire 120/208 volt models and three wire 120/240
volt models.
b.) 200 to 240 volts ac for two wire 200, 230 or 240
volt models.
4. Disconnect the brewer from the power source.
FIG.12 CONTROL THERMOSTAT
22978.0000