Filter
Top Products
23
15. Noise coming
from mixing
chamber
a) Whipper blade not properly aligned or
missing.
a) Check blade alignment, if needed replace blade and mixing
chamber.
16. Grinding noise
coming from
unit
a) Hopper not properly engaged in back, or
Hopper not seated properly
a) Check the mating between the auger motor’s
gear and hopper’s coupling/nut. Check also pin in base.
Pin must be dropped into hole in base.
17. Banging or
clicking noise
coming from
hoppers
a) One or more Hoppers are empty or almost
empty.
a) Fill Hoppers with product.
TANK ASS’Y - ILL. F
ITEM DESCRIPTION P/N QTY
1 SCREW, S.S., 1/4 - 20 x 5/8 P465A 3
2 HEATER, 120V 1700W
HEATER, 240V, 3000W
G267A
G266A
1
3 GASKET, TANK HEATER M502A 1
4 RUBBER GASKET, FOR SCREW (ITEM 1 P446A) M533A 2
5 TUBE K525A 1
6 TANK TOP RY98A 1
7 WATER LEVEL PROBE [K402A + P410A] K402Q 1
8 HI-LIMIT [TEMP.] L573A 1
9 GROMMET PLUG (.466 ID) F/TESTING TEMP. M494A 1
10 THERMISTER PROBE [L616A-PROBE, L617A-SILICONE TUBE] L639Q 1
11 HEATER DUCT HOUSING RJ82A 1
12 SILICONE BUTT SPLICED GASKET [GB2MD]
SILICONE BUTT SPLICED GASKET (GB3MD)
SILICONE BUTT SPLICED GASKET [GB4MD]
SILICONE BUTT SPLICED GASKET (GB5MD)
M498A
M499A
M500A
M473A
1
13 TANK COVER BRACKETS RI42A 2
14 TANK BODY RI38A 1
15 GROMMET (.466 ID) M461A 9*
16 DISPENSE VALVE (DUMP) L467A 3*
17 TANK INSULATION MATERIAL M183A 1
18 DRAIN HOSE (on a roll) M483A 1
19 SILICONE DRAIN PLUG M391A 1
20 COPPER PLATE- HEAT SINK FOR TRIAC
WINGED NUT for mounting plate to tank
K770A
P301A
1
2
21 TRIAC 35 AMP
SCREW for Triac
L623A
P182A
1
2
* Quantity shown is for GB3M5.5 IT. Quantities very for each unit.
16
18
14
12
4
3
17
2
1
20
5
6
1
10
7
19
21
11
13
15
9
8