Filter
Top Products
6
Installation Specifications
Rear wall or
countertop edge
countertop opening
29 1/4” (74.3 cm)
30 1/16” (76.2 cm)
cabinet opening
below countertop
below countertop
Cabinet face
Notch countertop
to width of cabinets
3/8” min. (9.5 mm)
countertop overhang
1” min. (2.6 cm)
to any combustibles
above counter both sides
20”
(50.8 cm)
to
23”
(58.4 cm)
20”
(50.8 cm)
24 5/8”
(62.5 cm)
max.
Countertop front
Rear wall or
countertop edge
countertop opening
29 1/4” (74.3 cm)
30 1/16” (76.2 cm)*
cabinet opening
below countertop
below countertop
Cabinet face
Notch countertop
to width of cabinets
3/8” min. (9.5 mm)
countertop overhang
1” min. (2.6 cm)
to any combustibles
above counter both sides
23”
(58.4 cm)
24 5/8”
(62.5 cm)
max.
Countertop front
Top View - Slide-In, Self-Rimming Installation,
3” Side Panels Installed
Top View - Slide-In, Self-Rimming Installation,
3” Side Panels Removed
Cabinet Cutouts for Self-Rimming Installation (Models RR30NIS and RR30NIFS Only)
* To create a “built-in look” on the front of the cabinet,
this dimension may be changed to 29 1/4” (74.3 cm),
with the width at the notches remaining 30 1/16”.
This configuration is only for models RR30NIS and
RR30NIFS with the side panels behind the door
removed.
• The self-rimming installation of the RR30NI[F]S range
creates a “built-in” look where the range trim overlaps
and rests on the countertop on both sides and in back.
• IMPORTANT: When installing the range in this
configuration, ventilation must be provided to allow
for cooling of the ranges internal components. See
diagram, left.
• Observe all vertical cabinet clearances on page 5.
• On self-rimming installations when sliding the range into
position, it will stop when the rear of the control panel or
side panels contact the notches toward the front of the
countertop.
Cut 3” dia. (7.6 cm) holes
at back bottom of cabinet
for ventilation.
Provide ventilation through
cabient both sides,
7 square inches min.
Location may vary.
34 3/4”
(88.3 cm)
to
36 7/8”
(93.7 cm)
(see diagrams)
Countertop
1 5/8 (41.1 cm)
max. thickness