Filter
Top Products
25
FAULT CODES
HOW TO RECOGNIZE A FAULT CODE
When a fault has occurred, the DishDrawer® will continuously beep every second.
Each fault code is shown in the following chart.
HOW TO ATTEND TO A FAULT CODE
1 Press the button to remove the fault code.
2 If the fault code and continuous beeps cannot be removed by pressing the button,
turn the power off at the power supply.
3 We recommend you check the following chart and correct the fault where possible.
4 After attending to the fault, turn the DishDrawer® on at the power supply.
5 If the fault code and continuous beeps remain, turn the water and power supply off to
the DishDrawer®.
6 When calling your Authorized Service Center advise them of the fault code that has
appeared on the DishDrawer®. This information will help the Authorized Service
Center respond to your request.
FAULT CODES POSSIBLE CAUSES WHAT TO DO
F1
Flood switch has been
activated.
Turn the water and power supply to the
DishDrawer
®
off and call your Authorized
Service Center.
F2
Motor problem. Call your Authorized Service Center.
F3
Temperature sensor failed. 1 Ensure water coming in through the
inlet hose is not hotter than 65
o
C. You
may need to install a tempering valve
on your water supply.
2 Call your Authorized Service Center.
F4
Faulty temperature sensor
or element
Call your Authorized Service Center.
F9
Electronics malfunction. Call your Authorized Service Center.
U1
Fill Fault 1 Turn the DishDrawer® water supply
on.
2 Ensure the spray arm can rotate about
the center, and if the DishDrawer®
is full of water, it will need to be
emptied manually.
3 Call your Authorized Service Center.