Filter
Top Products
16
RINSE AGENT DISPENSER
We highly recommend the regular use of liquid rinse agent to give the best drying
results. Rinse agent gives a streak free, sparkling clean look to glass and chinaware, in
addition it prevents metal from tarnishing. The rinse agent dispenser is on the inside
of the drawer, located underneath the detergent dispenser. The dispenser holds
approximately 50ml of rinse agent.
FILLING THE RINSE AGENT
DISPENSER
1 Turn the plug counter-clockwise and
remove.
2 Pour the rinse agent into the circular
opening.
3 Take care not to spill rinse agent into
the DishDrawer®. Any spillages must be
wiped up to prevent excess foaming. Failure to wipe rinse agent spillages may result
in a service call which will not be covered by warranty.
4 Fit the plug back into the original position.
How much rinse agent to use
The regulator may need adjusting to suit your water conditions. The lowest setting is
‘1’ and the highest is ‘5’. Refer to Option Adjustments section to adjust the rinse agent
setting. If there is excessive foam at the end of the wash, reduce the setting. If dishes
are wet or streaky after drying, increase the setting.
Rinse agent indicator light
If the rinse agent indicator light is red, refill the dispenser. If the rinse agent indicator
light is dimly lit or not lit at all, there is enough rinse agent for the wash.
Note
Lighter colored rinse agents will not dim the indicator light as effectively as darker
colored rinse agents.
When the rinse agent is being dispensed, you may notice some unusual noises during
the wash, this is normal.