Filter
Top Products
24
DishDrawer®
interior is
stained
Some foods, like tomato
based products, may
stain the inside of the
DishDrawer®.
Pre-rinse dishes before placing
in the DishDrawer®. Alternatively,
using the Rinse program after
adding the dishes may minimize
staining.
Foaming
Incorrect amount of
detergent.
Refer to the detergent section
or consult the detergent
manufacturer’s instructions.
Too much egg in the
wash load.
Increase the amount of detergent.
Rinse agent setting too
high.
Decrease the rinse agent setting.
No detergent
dispensed
Detergent was wet
when loaded.
Clean the dispenser and ensure
the dispenser is dry when adding
detergent.
Excessive
motor noise
The filter plate and/or
spray arm is incorrectly
placed.
Refer to the user maintenance
section for details on correct
placement.
No water in the motor
area.
This usually occurs on the first use
or when the DishDrawer® has not
been used for long periods of time.
Run the DishDrawer® through a
wash program.
Water leaking
Drain hose
disconnected from
waste pipe.
Reconnect the drain hose to the
waste pipe.
Supply inlet hose not
properly connected.
Ensure the inlet hose is connected
securely.
Other leaks. Turn water and power supplies
to the DishDrawer® off. Call your
dealer or Authorized Service Agent.
DishDrawer®
will not open
Childlock function is on
or the Closed Drawer
option is on, or both.
Turn the Lock function off. Hold
down the button until the light
above the button disappears and/or
press the button to open the
DishDrawer®.
PROBLEM POSSIBLE CAUSE WHAT TO DO