Filter
Top Products
21
Cleaning the Spray Arm & Filter plate
Ensure the DishDrawer® is cool before you
start cleaning and follow the instructions for
removing the drain filter and spray arm.
1 Remove the basket carefully. Lift from the
back end first to prevent knocking the
detergent and rinse agent dispenser.
2 Lift the spray arm and shake any foreign
material out.
Rinse the spray arm under clean running
water and wipe with a damp cloth.
3 In the center of the filter plate there are two
rings. Hold the center ring still and turn the
outer ring anti-clockwise, about a
1
/
8
turn.
This will release the filter plate.
4 Lift the filter plate out.
When cleaning the underside of the filter
plate, take care handling the sharp outer
edge to avoid the risk of cuts.
Remove any foreign material, wash in hot
soapy water and rinse thoroughly in clean
water. The heater plate can be wiped with a
damp cloth.
5 Replace the filter plate so it lies flat in the
base of the drawer ensuring the filter plate is
fully locked into position with the center ring.
6 To lock the filter plate into position, ensure
the lines align with each other (refer to the
diagram for the correct position). The filter
plate must not be able to move about freely.
7 Replace the spray arm back onto the impeller.
8 Replace the basket, lowering the front edge
of the basket into position first.
Note
Where there is broken crockery or glass in the drawer, it must be carefully removed to
prevent damage to the DishDrawer®.
Correct Locking Position of
Filter Plate with Motor Assembly
(under Spray Arm)
a Outer Ring
b Impeller
c Correct Alignment marks
d Center Ring
d
c
b
a