Filter
Top Products
5/25
©SEIKO EPSON CORPORATION 2008-2009. All rights reserved.
You cannot find your device on the list:
If your device is not listed in the List view, make sure the device is turned on and that it is located within the
same segment as your computer.
3. Click the Configuration button.
Or double-click the network interface device you want to configure.
4. In the Network Interface Card Properties window that appears, select the tab for the protocol that you
want to configure.
Configure the network interface settings to suit your operational environment. Refer to the following sections for
information on each protocol setting.
Location See 6.3 Printer Menu
Administrator Name, Return to Default See 6.4 Print Server Menu
TCP/IP See 6.5 TCP/IP Menu
Wireless Network See 6.6 Wireless Menu
5. When you are done with all the settings, click OK.
6. In the window that appears, click OK again.
7. The Password window appears.
Initially, no password is set.
z If you do not want to set your password yet, just click OK here without entering anything. Your settings
will be sent to the network interface.
z If you do want to set your password, refer to 5. Setting the Password.
Note:
Do not turn off the device or send other data to it until you see the message “Configuration successfully
completed” as TMNet WinConfig is still communicating with the device.
8. It takes a maximum of three minutes for all the settings to become effective.
Do not turn off the device until that happens. After about three minutes have passed, choose Refresh from the
View menu and confirm the current settings.
This completes the configuration of the network interface.
Note:
You are advised to store the settings you have made in a safe place.