Filter
Top Products
Chassis Grounding (optional)
If additional chassis grounding is desired, connect a
1
⁄
4
-inch female spade connector to the ground tab at the
rear of the tape drive. Or, connect an M3-0.5 6 mm
self-tapping screw to the grounding hole. The ground tab
and grounding hole are shown in Figure 8 on page 19.
Figure 14 Mounting holes on the sides of the tape drive
Figure 15 Mounting holes on the bottom of the tape
drive
42 EXB-8500/EXB-8500c 306261